Instruction

Using the applicator menthol.click it is very simple

Watch the short instruction

applicator instruction_1

1. Open the top cover of the applicator and add the balls, don't forget to close!

 

2. Depending on the type of cigarette, you will find an adapter for thin cigarettes at the bottom.

3. Insert the cigarette with the filter side into the outer opening on the bottom of the applicator.

 

4. Make a hole in it using the vertical lever to the very end (in the case of thin cigarettes, it is recommended to move the lever a few times. cigarette).

applicator instruction_3
applicator instruction_3

3. Insert the cigarette with the filter side into the outer opening on the bottom of the applicator.

 

4. Make a buttonhole using the vertical lever all the way to the end.

applicator instruction_2

5. From this step, keep the applicator in an upright position! Gently use the horizontal lever to release one ball.

 

6. Use the vertical lever again to install the ball in the cigarette (in the case of thin cigarettes it is recommended to insert the ball gradually a few times using the lever to avoid breakage of the ball at the beginning of the filter).

7. Done! Click the ball and enjoy your menthol cigarette!

applicator instruction_4
applicator instruction_4

7. Done! Click the ball and enjoy your menthol cigarette!

APPLICATOR - QUESTIONS / ANSWERS / HOW TO FIX

How to use the ball applicator with thin / medium cigarettes?

In the box with the applicator there is an adapter for the selected type of cigarette. Put it in the cigarette holder. On the right side there is a place for your favorite adapter, which you can always have with you!

 

Can I use the heets applicator?

For applying menthol.click balls to heets filters, we recommend using a toothpick, which we add to each package of balls that you order.

 

How many balls are in the applicator?

The applicator has a magazine for 100 BBs. You can pour the entire sample of 100 pieces or an oval box.

The ball applicator stopped working - what should I do?

Sometimes it happens that one of the balls breaks in our applicator (e.g. due to a fall, high temperature, incorrect use of the ball feeder, when there is more than 1 ball in the punching chamber), then the appropriate steps should be taken:
1. Remove BBs from the magazine, keep the closure open
2. Prepare a bowl with hot water and washing up liquid.
3. Place the applicator in the bowl and shake it in water so that the water reaches everywhere, then shake the applicator over e.g. a sink to rinse the water
4. Repeat step no. 2-3 times.
5. Put the applicator aside for 5-10 minutes for the applicator to dry, then add some beads to check if everything is OK
6. If the above method did not work - please contact us at [email protected]

I have another question / problem regarding the applicator

Please contact us at [email protected]